Movie Film

Many people who handle their own motion picture is the actual drying of the most complicated. How to avoid marking of the film …. and results in nice looking, clean professional?

Get a plastic board covered with about 2 feet long and screw in the eyelets at regular intervals. Make a series of wire S-hooks to support the film perforations. It's a good idea to use a file to lower one end to a point to make it easy and quick hook in the movie.

The board is hung near the ceiling or supported relatively dust spare room. Maybe use hooks to do this. A large plastic sheet about 4.5 meters long sticks to the rear edge of the plate. The other end is connected to a piece of corn. Large enough for two hooks at the front of the Board, for hanging the plug.

href = "Http://2.bp.blogspot.com/_KsrfillTmzs/STmponoY29I/AAAAAAAAAB0/kgtHD4hauMw/s1600-h/film+dryer.jpg">

You also need for a card length about the same width as the Board. Also a good quality sponge: just cut it with scissors. Oh, and some clothes pegs.

After processing and wash the movies, give it a final rinse with distilled water to remove calcareous deposits, if you live in a hard water area. Then add a few drops of wetting agent and to the spiral of processing a final whistle. Rinse the sponge and squeeze almost dry. Take the spiral of the tray, and attach the end of the film to the first S-hook. As the spiral rotates the film should unwind easily. This is always a exciting time as you can see the frames of the movie first, but try to resist for long a look as there are dust motes in homing! Working fairly quickly, but carefully. Have a chair in hand to clean up the spiral (unless you have three hands). Now, with about 2 meters of film unwinding turn their attention to the sponge. Stay near the top film at its edges, place the sponge in its slot, then gently pull it along. Relax another 2 feet of film and place of the spiral at the top of the table, while the length of the sponge. Then very carefully place the film in a hole Next on the S hook. Then another hook to maintain close ties and hanging it apart.

Carry on this way until entire film is unrolled and hanging in long loops almost to the ground. Depending on the length of the film may have to retrace their steps with more hooks across the board. Always make sure the sponge is squeezed and scrupulously clean, then zero the film will never be smooth.

Finally, unroll the plastic behind the film loops, and near where the floor-length card in it. This weighs on the blade and ensures that do not touch the film. Unroll the rest of the leaf and hang the pin. Plugs of the sides together, but significant gaps sheet to allow air passage. Now you a container of powder essentially free. Leave the film in which perhaps 12 hours, as desired by the bone dry before the wound on a reel of the project. With luck, you find your movie in perfect condition, without any dirt or marks. If you still see the strange chalk mark, which does not affect the movie in fact, that can be removed with a soft cloth.

The key to decent performance is absolute cleanliness. If you can not find a room free of dust, try to seize the bathroom, in fact, the bathroom could be a good place to hang the film and easy to fill.

And, for those who have not yet tried the home development, is a fantastic feeling knowing film project I've done it all yourself. !

Cam Blog "> www.filmcamblog.blogspot.com

About the Author:

For more of my photos/articles and such, visit my blog!

or to purchase vintage photographic equipment visit:-

Article Source: ArticlesBase.com – How to Dry Your Movie Film

PMS: The Horror Movie – Film Riot